Huawei Quidway S6700 series User Manual

RRPP Protocol Status: Disable
RRPP Working Mode: HW
RRPP Linkup Delay Timer: 1 sec (0 sec default).
Number of RRPP Domains: 1
Domain Index : 1
Control VLAN : major 30 sub 31
Protected VLAN : Reference Instance 10
Hello Timer : 1 sec(default is 1 sec) Fail Timer : 6 sec(default is 6 sec)
Ring Ring Node Primary/Common Secondary/Edge Is
ID Level Mode Port Port Enabled
-------------------------------------------------------------------------------
1 0 M XGigabitEthernet0/0/1 XGigabitEthernet0/0/2 No
Run the display rrpp verbose command, and you can view detailed information such as the
control VLAN, protected VLAN, timers, node mode, and port status. The following is an
example:
<Quidway> display rrpp verbose domain 1 ring 1
Domain Index : 1
Control VLAN : major 400 sub 401
Protected VLAN : Reference Instance 30
Hello Timer : 1 sec(default is 1 sec) Fail Timer : 6 sec(default is 6 sec)
RRPP Ring : 1
Ring Level : 0
Node Mode : Master
Ring State : Complete
Is Enabled : Enable Is Active : Yes
Primary port : XGigabitEthernet0/0/1 Port status: UP
Secondary port : XGigabitEthernet0/0/2 Port status: BLOCKED
Run the display rrpp statistics command, and you can view the statistics of sent and received
packets. The following is an example:
<Quidway> display rrpp statistics domain 1 ring 1
RRPP Ring : 1
Ring Level : 0
Node Mode : Master
Is Active : Yes
Primary port : XGigabitEthernet0/0/1
Packet LINK COMMON COMPLETE EDGE MAJOR Packet
Direct HEALTH DOWN FDB FDB HELLO FAULT Total
-------------------------------------------------------------------------------
Send 2934 0 1 1 0 0 2936
Rcv 0 1 0 0 0 0 1
Secondary port: XGigabitEthernet0/0/2
Packet LINK COMMON COMPLETE EDGE MAJOR Packet
Direct HEALTH DOWN FDB FDB HELLO FAULT Total
-------------------------------------------------------------------------------
Send 0 0 1 0 0 0 1
Rcv 2928 1 0 0 0 0 2929
3.4 Configuring RRPP Multi-Instance
RRPP multi-instance is based on domains. Multiple RRPP domains can be configured on a
physical ring. In a domain, all ports, nodes, and topologies must comply with basic RRPP
principles. Therefore, a physical ring has multiple master nodes. Each master node independently
detects the completeness of the physical ring and blocks or unblocks its own secondary ports
accordingly.
Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability 3 RRPP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
61

Huawei Quidway S6700 series Specifications

General

Brand	Huawei
Model	Quidway S6700 series
Category	Network Router
Language	English