Huawei Quidway S6700 series User Manual

l Spanning Tree Protocol (STP) is enabled on the interface.
l The interface has been added to an Eth-Trunk.
l The interface has been added to a Monitor Link group.
l The interface has been added to another Smart Link group.
l STP is configured on the interface.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The system view is displayed.
Step 3 Run:
stp disable
STP is disabled on the interface.
Step 4 Run:
quit
Return to the interface view.
Step 5 Run:
smart-link group group-id
The Smart Link group view is displayed.
Step 6 Run:
port interface-type interface-number master
An interface is added to the Smart Link group and is specified as the master interface.
Step 7 Run:
port interface-type interface-number slave
Another interface is added to the Smart Link group and is specified as the slave interface.
A Smart Link group consists of a master interface and a slave interface. By default, a Smart Link
group does not have interfaces.
----End
2.2.4 Enabling the Sending of Flush Packets
Context
When the active and standby links of the Smart Link group switch, the existing forwarding
entries no longer apply to the new topology. All the MAC address entries and ARP entries on
the network need to be updated. Then the Smart Link group sends Flush packets to ask other
devices to update the MAC address table and ARP entries.
Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability 2 Smart Link and Monitor Link Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
19

Huawei Quidway S6700 series Specifications

General

Brand	Huawei
Model	Quidway S6700 series
Category	Network Router
Language	English