By default, the priority is 100. Priority 0 is reserved for special use, and priority 255
is reserved for the IP address owner whose priority cannot be configured. The value
of a priority ranges from 1 to 254.
----End
6.3.4 (Optional) Configuring the Sending Mode of VRRP Packets
in Super-VLAN
You can configure the sending mode of VRRP advertisement packets for a super VLAN on
VLANIF interfaces as required.
Context
Do as follows on a VRRP switch that is configured with a super-VLAN:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface vlanif vlan-id
The VLAN interface view is displayed.
Step 3 Run:
vrrp advertise send-mode { sub-vlan-id | all }
The sending mode of VRRP advertising messages is configured.
By default, a super VLAN sends VRRP Advertisement packets only to the sub-VLAN with the
smallest VLAN ID among all the sub-VLANs in Up state.
----End
6.3.5 Checking the Configuration
By viewing the status of a VRRP backup group, you can check whether the configurations are
successful.
Prerequisite
The configurations of the VRRP backup group function are complete.
Procedure
l Run the display vrrp [ interface interface-type interface-number [ virtual-router-id ] ]
[ brief ] command to check the status of VRRP backup group.
l Run the display vrrp6 [ interface interface-type interface-number [ vrid virtual-router-
id ] ] [ brief ] command to check the status and the configurations of the VRRP6 backup
group.
----End
Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability 6 VRRP and VRRP6 Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
222
To Next Page
Loading...
Need help?
General
