<Quidway> display bfd configuration static for-ip verbose
--------------------------------------------------------------------------------
BFD Session Configuration Name : bfd2
--------------------------------------------------------------------------------
Local Discriminator : 20 Remote Discriminator : 10
BFD Bind Type : Interface(Vlanif110)
Bind Session Type : Static
Bind Peer IP Address : 11.1.1.1
Bind Interface : Vlanif110
TOS-EXP : 7 Local Detect Multi : 3
Min Tx Interval (ms) : 1000 Min Rx Interval (ms) : 1000
Proc Interface Status : Disable WTR Interval (ms) : -
Bind Application : No Application Bind
Session Description : -
--------------------------------------------------------------------------------
Total Commit/Uncommit CFG Number : 1/0
Run the display bfd session command, and you can view information about a BFD session.
<Quidway> display bfd session all for-ip verbose
--------------------------------------------------------------------------------
Session MIndex : 258 (One Hop) State : Up Name : bfd2
--------------------------------------------------------------------------------
Local Discriminator : 20 Remote Discriminator : 10
Session Detect Mode : Asynchronous Mode Without Echo Function
BFD Bind Type : Interface(Vlanif110)
Bind Session Type : Static
Bind Peer IP Address : 11.1.1.1
NextHop Ip Address : 11.1.1.1
Bind Interface : Vlanif110
FSM Board Id : 0 TOS-EXP : 7
Min Tx Interval (ms) : 1000 Min Rx Interval (ms) : 1000
Actual Tx Interval (ms): 1000 Actual Rx Interval (ms): 1000
Local Detect Multi : 3 Detect Interval (ms) : 3000
Echo Passive : Disable Acl Number : -
Destination Port : 3784 TTL : 255
Proc Interface Status : Disable
WTR Interval (ms) : -
Active Multi : 3
Last Local Diagnostic : No Diagnostic
Bind Application : No Application Bind
Session TX TmrID : 4491 Session Detect TmrID : 4492
Session Init TmrID : - Session WTR TmrID : -
Session Echo Tx TmrID : -
PDT Index : FSM-0 | RCV-0 | IF-0 | TOKEN-0
Session Description : -
--------------------------------------------------------------------------------
Total UP/DOWN Session Number : 1/0
5.7 Configuring the Interval at Which Trap Messages Are
Sent
The interval at which trap messages are sent is set, helping a device to suppress BFD trap
messages.
5.7.1 Establishing the Configuration Task
Before configuring the interval at which trap messages are sent, familiarize yourself with the
applicable environment, complete the pre-configuration tasks, and obtain the data required for
the configuration. This will help you complete the configuration task quickly and accurately.
Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability 5 BFD Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
200
To Next Page
Loading...
Need help?
General
