Huawei Quidway S6700 series User Manual

The system view is displayed.
Step 2 Run:
rrpp domain domain-id
The domain view is displayed.
Step 3 Run:
ring ring-id enable
The RRPP ring is enabled.
----End
3.3.9 Enabling RRPP
To activate an RRPP ring, you must enable RRPP and the RRPP ring.
Context
NOTE
The RRPP ring can be activated only when both the RRPP ring and RRPP protocol are enabled.
Do as follows on all switches in the RRPP domain:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
rrpp enable
The RRPP protocol is enabled.
----End
3.3.10 (Optional) Setting the Values of RRPP Domain Timers
Two timers, that is, the Hello timer and the Fail timer are used when master nodes are sending
and receiving RRPP protocol packets. The Hello timer is used when primary ports are sending
Hello packets. The Fail timer is used when secondary ports are receiving the Hello packets sent
by the local node.
Context
Do as follows on the master node in the RRPP domain:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability 3 RRPP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
59

Huawei Quidway S6700 series Specifications

General

Brand	Huawei
Model	Quidway S6700 series
Category	Network Router
Language	English