Huawei Quidway S6700 series - Example for Configuring a Single RRPP Ring

3.6.1 Example for Configuring a Single RRPP Ring
Networking Requirements
As shown in Figure 3-5, Switch A, Switch B, and Switch C support the RRPP function. Switch
A, Switch B, and Switch C are on ring 1 of RRPP domain 1. The data of VLANs 100 to 300
needs to be protected.
Figure 3-5 Networking diagram of a single RRPP ring
XGE0/0/1
XGE0/0/2
XGE0/0/1
XGE0/0/2
XGE0/0/2
XGE0/0/1
SwitchB
Ring 1
SwitchA
SwitchC
Primary Port
Secondary port
Configuration Roadmap
The configuration roadmap is as follows:
1. Map instance 1 to VLANs 100 to 300.
2. Locate Switch A, Switch B, and Switch C on ring 1 of RRPP domain 1.
3. Configure Switch A as the master node on ring 1, and configure Switch B and Switch C as
transit nodes on ring 1.
Data Preparation
To complete the configuration, you need the following data:
l Numbers of the RRPP interfaces
l Control VLAN ID of ring 1
Procedure
Step 1 Map instance 1 to VLANs 100 to 300.
<Quidway> system-view
[Quidway] sysname SwitchA
[SwitchA] stp region-configuration
[SwitchA-mst-region] instance 1 vlan 20 21 100 to 300
[SwitchA-mst-region] active region-configuration
[SwitchA-mst-region] quit
Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability 3 RRPP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
74