Huawei Quidway S6700 series - Page 189

Figure 4-7 Networking diagram for configuring association between EFM OAM modules
SwitchA
SwitchB
SwitchC
XGE0/0/2
XGE0/0/2XGE0/0/1
XGE0/0/1
EFM OAM EFM OAM
Configuration Roadmap
The configuration roadmap is as follows:
1. Enable EFM OAM globally on Switch A, Switch B, and Switch C.
2. Configure EFM OAM on XGE 0/0/1 of Switch B and XGE 0/0/2 of Switch C to work in
passive mode.
3. Enable EFM OAM on interfaces of the S6700s.
4. Configure association between EFM OAM modules on Switch B.
Procedure
Step 1 Enable EFM OAM globally.
# Configure Switch A.
<SwitchA> system-view
[SwitchA] efm enable
# Configure SwitchB.
<SwitchB> system-view
[SwitchB] efm enable
# Configure Switch C.
<SwitchC> system-view
[SwitchC] efm enable
Step 2 Configure the operation mode of interfaces.
# Configure Switch B.
[SwitchB] interface xgigabitethernet 0/0/1
[SwitchB-XGigabitEthernet0/0/1] bpdu enable
[SwitchB-XGigabitEthernet0/0/1] efm mode passive
[SwitchB-XGigabitEthernet0/0/1] quit
# Configure SwitchC.
[SwitchC] interface xgigabitethernet 0/0/2
[SwitchC-XGigabitEthernet0/0/2] bpdu enable
[SwitchC-XGigabitEthernet0/0/2] efm mode passive
[SwitchC-XGigabitEthernet0/0/2] quit
Step 3 Enable EFM OAM on interfaces.
# Configure Switch A.
[SwitchA] interface xgigabitethernet 0/0/1
[SwitchA-XGigabitEthernet0/0/1] bpdu enable
[SwitchA-XGigabitEthernet0/0/1] efm enable
[SwitchA-XGigabitEthernet0/0/1] quit
Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability 4 Ethernet OAM Configuration-EFM
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
179