Huawei Quidway S6700 series - Page 295

After completing the configuration, run the display loopback swap-mac information
command to verify the configuration. If the configuration is correct, send Ethernet frames from
the tester to test network performance.
[SwitchB] display loopback swap-mac information
Loopback type : remote
Loopback state : running
Loopback test time(s) : 80
Loopback interface : XGigabitEthernet0/0/1
Loopback output interface : XGigabitEthernet0/0/1
Loopback source MAC : 0018-2000-0085
Loopback destination MAC : 0018-2000-0070
Loopback vlan : 100
Loopback inner vlan : 0
Loopback packets : 0
----End
Configuration Files
l Configuration file of Switch B
#
sysname SwitchB
#
vlan batch 100
#
interface XGigabitEthernet0/0/1
port link-type trunk
port trunk allow-pass vlan 100
loopback remote swap-mac source-mac 0018-2000-0085 dest-mac 0018-2000-0070
vlan
100 timeout 80
#
return
Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability 7 MAC Swap Loopback Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
285