Huawei Quidway S6700 series User Manual

Step 7 Enable Smart Link on Switch A.
[SwitchA-smlk-group1] smart-link enable
[SwitchA-smlk-group1] quit
Step 8 Enable the receiving of Flush packets.
# Configure Switch B.
<SwitchB> system-view
[SwitchB] interface xgigabitethernet 0/0/1
[SwitchB-XGigabitEthernet0/0/1] smart-link flush receive control-vlan 10 password
simple 123
[SwitchB-XGigabitEthernet0/0/1] quit
# Configure Switch C.
<SwitchC> system-view
[SwitchC] interface xgigabitethernet 0/0/1
[SwitchC-XGigabitEthernet0/0/1] smart-link flush receive control-vlan 10 password
simple 123
[SwitchC-XGigabitEthernet0/0/1] quit
Step 9 Verify the configuration.
# Run the display smart-link group command to view information about the Smart Link group
on Switch A. If the following information is displayed, it indicates that the configuration is
successful.
l The Smart Link function is enabled.
l The control VLAN ID is 10.
l XGE 0/0/1 is the master interface and is in Active state, and XGE 0/0/2 is the slave interface
and is in Inactive state. The load balancing function is configured.
[SwitchA] display smart-link group 1
Smart Link group 1 information :
Smart Link group was enabled
Wtr-time is: 30 sec.
Load-Balance Instance: 10
There is no protected-vlan reference-instance
DeviceID: 0025-9e80-2494 Control-vlan ID:
10
Member Role State Flush Count Last-Flush-Time
----------------------------------------------------------------------
XGigabitEthernet0/0/1 Master Active 1 0000/00/00 00:00:00 UTC+00
:00
XGigabitEthernet0/0/2 Slave Inactive 0 0000/00/00 00:00:00 UTC+00
:00
# Run the shutdown command to shut down XGE 0/0/1, and you can find that XGE 0/0/1 is in
Inactive state and XGE 0/0/2 is in Active state.
[SwitchA] interface xgigabitethernet 0/0/1
[SwitchA-XGigabitEthernet0/0/1] shutdown
[SwitchA-XGigabitEthernet0/0/1] display smart-link group 1
Smart Link group 1 information :
Smart Link group was enabled
Wtr-time is: 30 sec.
Load-Balance Instance: 10
There is no protected-vlan reference-instance
DeviceID: 0025-9e80-2494 Control-vlan ID:
10
Member Role State Flush Count Last-Flush-Time
----------------------------------------------------------------------
XGigabitEthernet0/0/1 Master Inactive 1 0000/00/00 00:00:00 UTC+00
:00
Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability 2 Smart Link and Monitor Link Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
39

Huawei Quidway S6700 series Specifications

General

Brand	Huawei
Model	Quidway S6700 series
Category	Network Router
Language	English