Switch A is also an edge of the subring, with XGE 0/0/2 as the common interface and
XGE 0/0/3 as the edge interface.
l Run the display rrpp verbose domain command on Switch A. The following information
is displayed:
[SwitchA] display rrpp verbose domain 1
Domain Index : 1
Control VLAN : major 10 sub 11
Protected VLAN : Reference Instance 1
Hello Timer : 1 sec(default is 1 sec) Fail Timer : 6 sec(default is 6 sec)
RRPP Ring : 1
Ring Level : 0
Node Mode : Transit
Ring State : Linkup
Is Enabled : Enable Is Active : Yes
Primary port : XGigabitEthernet0/0/2 Port status: UP
Secondary port: XGigabitEthernet0/0/1 Port status: UP
RRPP Ring : 2
Ring Level : 1
Node Mode : Edge
Ring State : Linkup
Is Enabled : Disable Is Active : No
Common port : XGigabitEthernet0/0/2 Port status: UP
Edge port : XGigabitEthernet0/0/3 Port status: UP
l Run the display rrpp brief command on Switch D. The following information is displayed:
[SwitchD] display rrpp brief
Abbreviations for Switch Node Mode :
M - Master , T - Transit , E - Edge , A - Assistant-Edge
RRPP Protocol Status: Enable
RRPP Working Mode: HW
RRPP Linkup Delay Timer: 0 sec (0 sec default).
Number of RRPP Domains: 1
Domain Index : 1
Control VLAN : major 10 sub 11
Protected VLAN : Reference Instance 1
Hello Timer : 1 sec(default is 1 sec) Fail Timer : 6 sec(default is 6 sec)
Ring Ring Node Primary/Common Secondary/Edge Is
ID Level Mode Port Port Enabled
-------------------------------------------------------------------------
1 0 T XGigabitEthernet0/0/2 XGigabitEthernet0/0/1 Yes
2 1 A XGigabitEthernet0/0/2 XGigabitEthernet0/0/3 Yes
You can find that RRPP is enabled on Switch D. The main control VLAN is VLAN 10, and
the sub control VLAN is VLAN 11. Switch D is the transit node of the major ring, with
GXGigabitEthernet0/0/2 as the primary interface and XGigabitEthernet0/0/1 as the
secondary interface. Switch D is also the assistant edge node of the major ring, with
XGigabitEthernet0/0/2 as the common interface and XGigabitEthernet0/0/3 as the edge
interface.
l Run the display rrpp verbose domain command on Switch D. The following information
is displayed:
[SwitchD] display rrpp verbose domain 1
Domain Index : 1
Control VLAN : major 10 sub 11
Protected VLAN : Reference Instance 1
Hello Timer : 1 sec(default is 1 sec) Fail Timer : 6 sec(default is 6 sec)
RRPP Ring : 1
Ring Level : 0
Node Mode : Transit
Ring State : Linkup
Is Enabled : Enable Is Active : Yes
Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability 3 RRPP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
85
To Next Page
Loading...
