Huawei V300R005 - Example for Configuring Logging in to the Router through Password

Quidway NetEngine80
Configuration Guide - Basic Configurations 5 User Management
Issue 04 (2009-12-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5-31
5.8.1 Example for Configuring Logging In to the Router Through
Password
Networking Requirements
The COM port of the PC is connected with the Console port. Set the priority of VTY0 to 2
and authenticate the passwords of users. Users need to input the password Huawei to log on
successfully.
After login, if the operations are not carried out in 30 minutes, it means that the user-interface
is disconnected from the router.
Configuration Roadmap
The configuration roadmap is as follows:
1. Enter the user interface.
2. Configure the priority of VTY0 as 2.
3. Configure the simple authentication and the disconnect time.
Data Preparation
To complete the configuration, you need the following data:
z
The password of the authentication mode
z
The connection time
Configuration Procedure
<Quidway> system-view
[Quidway] user-interface vty 0
[Quidway-ui-vty0] user privilege level 2
[Quidway-ui-vty0] authentication-mode password
[Quidway-ui-vty0] set authentication password simple huawei
[Quidway-ui-vty0] idle-timeout 30
# Use the display this command to check all configurations.
[Quidway-ui-vty0] display this
#
user-interface con 0
user-interface aux 0
user-interface vty 0
user privilege level 2
set authentication password simple huawei
idle-timeout 30 0
user-interface vty 1 4
#
return
# Use the display current-configuration command to view the system files.
[Quidway] display current-configuration
#
sysname Quidway