Quidway NetEngine80
Configuration Guide - Basic Configurations 4 Basic Configuration
Issue 04 (2009-12-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4-5
The system view is displayed.
Step 2 Run:
command-privilege level rearrange
Update the command level in batch.
When no password for level 15 user is configured, the system prompts the user to set a
super-password for the level 15 user. At the same time, the system asks if the user wants to
continue to update the command line level. Then, just select "N" to set a password. If you
select "Y", the command level can be updated in batch directly. This results in that the user
that does not log in through the Console port fails to update the level.
Step 3 Run:
command-privilege level level view view-name command-key
The command level is configured. With the command, you can specify the level and view for
multiple commands at one time (command-key)..
----End
If the user does not adjust a command level separately, after the command level is updated, all
originally-registered command lines adjust automatically according to following rules:
z
The commands of Level 0 and Level 1 remain still.
z
The command Level 2 is updated to Level 10 and Level 3 is updated to Level 15.
z
No command lines exist in Level 2 to Level 9 and Level 11 to Level 14.The user can
adjust the command lines to these levels separately to refine the management of
privilege.
From Level 2 to Level 10 and from Level 3 to Level 15, this is not a two-step process, but one-step by
batch.
4.3 Configuring Basic User Environment
4.3.1 Establishing the Configuration Task
Applicable Environment
The user can log in to a router with lower level, perform simple configurations or view
configurations. When the configuration is complicated, the user needs to change to a high
identity level. Thus, it requires the user to configure the basic environment for changing
levels.
Pre-configuration Tasks
Before configuring the basic environment for the user, complete the following task:
z
Powering on the router properly
To Next Page
Loading...
