4 Basic Configuration
Quidway NetEngine80
Configuration Guide - Basic Configurations
4-8 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 04 (2009-12-20)
z
System statistics message
z
Restart message on the AMB
See the related sections for display commands about protocols and interfaces. The following
only shows the system display commands.
Run the following commands in all views.
4.4.1 Displaying System Configuration
Run one or more of following commands according to your needs:
z
Run the display version command to display the system edition.
z
Run the display clock command to display the system time.
z
Run the display users [ all ] command to display the terminal user.
z
Run the display saved-configuration command to display the original configuration.
z
Run the display current-configuration command to display the current configuration.
4.4.2 Displaying System Status
Run one or more of following commands according to your needs:
z
Run the display debugging [ interface interface-type interface-number ]
[ module-name ] command to display the debugging status.
z
Run the display this command to display the configuration of the current view.
4.4.3 Collecting System Diagostic Information
Run the following command according to your needs:
Run the display diagnostic-information [ file-nme ] command to display the system
diagnosis information.
When the system fails or performing the routine maintenance, you need to collect a lot of
information to locate the fault. But you cannot collect enough information, because there are
many display commands. You can use the display diagnostic-information command to
collect the running information about the current modules in the system.
The display diagnostic-information command collects the information for once after
running the following commands, including display clock, display version, display cpu,
display interface, display current-configuration, display saved-configuration, display
history-command and so on.
To Next Page
Loading...
