Huawei V300R005 - Configuring User Authentication

5 User Management
Quidway NetEngine80
Configuration Guide - Basic Configurations
5-14 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 04 (2009-12-20)
The switch of incoming call or outgoing call is set.
----End
5.3.6 Configuring User Authentication
The router supports user authentication of three types:
z
AAA authentication: requires the user name and password.
z
Password authentication: requires no user name but a password must be set. Otherwise,
the user cannot log in to the router through the console interface.
z
None: requires neither user name nor password. No authentication is needed when the
user logs in to the router.
Configuring AAA Authentication
Do as follows on the router:
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
user-interface aux 0
The AUX user interface view is displayed.
Step 3 Run:
authentication-mode aaa
Authentication mode is set to AAA.
Step 4 Run:
quit
Exit from the AUX user interface view.
Step 5 Run:
aaa
The aaa view is displayed.
Step 6 Run:
local-user user-name password { simple | cipher } password
Local user and password are configured.
----End
Configuring Password Authentication
Do as follows on the router: