Huawei V300R005 - Creating an SSH User; Configuring SSH for the VTY User Interface

Quidway NetEngine80
Configuration Guide - Basic Configurations 9 Telnet and SSH
Issue 04 (2009-12-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9-11
No. Procedure
9 Checking the Configuration
9.3.2 Creating an SSH User
Do as follows on the router:
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ssh user user-name
The SSH user is created.
If the SSH user that has the authentication mode of password or password-rsa is created, you
need to create a local user that has the same name in the AAA view.
1. Run:
aaa
The AAA view is displayed.
2. Run:
local-user username password {cipher| simple } password
The local user is created.
----End
If the SSH user is not created separately, you can create the SSH user when performing the following
configurations:
z
Configuring the Authentication Mode for SSH Users
z
Configuring the Service Type of SSH Users
9.3.3 Configuring SSH for the VTY User Interface
Do as follows on the router:
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
user-interface [ vty ] first-ui-number [ last-ui-number ]
The VTY user interface is displayed.
Step 3 Run: