2 Establishment of the Configuration Environment
Quidway NetEngine80
Configuration Guide - Basic Configurations
2-4 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 04 (2009-12-20)
Step 1 Press Enter until a command line prompt such as Quidway appears. Now enter the
configuration environment in the user view.
----End
2.3 Logging In to Router Through Telnet
2.3.1 Establishing the Configuration Task
Applicable Environment
If you know the IP address of the router, you can log in to the router through Telnet for local
or remote configuration.
Pre-configuration Tasks
Before configuring the router through Telnet, complete the following tasks:
z
Powering on devices and performing a self-check
z
Preparing the PC (including the serial port and Ethernet crossover/direct network cable
Data Preparation
To log in to the router through Telnet, you need the following data.
No. Data
1 IP address of the PC
2 IP address of the Ethernet interface on the router
3 User information accessed through Telnet (including user name, password and
authentication mode)
Configuration Procedures
To configure the router through Telnet, complete the following procedures.
No. Procedure
1 Establishing the Physical Connection
2 Configuring Login User Parameters
3 Logging In from the Telnet Client
To Next Page
Loading...
