Huawei V300R005 - Stopping LPU Patch Operation

Quidway NetEngine80
Configuration Guide - Basic Configurations 12 Patch Management
Issue 04 (2009-12-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
12-13
12.8 Stop Running the LPU Patch
12.8.1 Establishing the Configuration Task
Applicable Environment
After a patch is activated, you need to judge that the patch has achieved the expected effect. If
the patch does not become valid, you need to activate the patch.
A patch can be deactivated only after it is activated.
Pre-configuration Tasks
None.
Data Preparation
None.
Configuration Procedures
No. Procedure
1 Deactivating the LPU Patch
12.8.2 Deactivating the LPU Patch
Do as follows on the router to be upgraded.
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
patch deactive slot slot-id
The LPU patch is deactivated.
----End
12.9 Unloading the LPU Patch
12.9.1 Establishing the Configuration Task
Applicable Environment
When upgrading the system software or installing a new patch, you need to delete the running
patch.