Quidway NetEngine80
Configuration Guide - Basic Configurations 5 User Management
Issue 04 (2009-12-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5-15
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
user-interface aux 0
The AUX user interface view is displayed.
Step 3 Run:
authentication-mode password
Authentication mode is set to password.
Step 4 Run:
set authentication password { cipher | simple } password
Step 5 Set password for this mode.
----End
Configuring Non-Authentication
Do as follows on the router:
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
user-interface aux 0
The AUX user interface view is displayed.
Step 3 Run:
authentication-mode none
Authentication mode is set to none.
----End
5.3.7 Checking the Configuration
Run the following commands to check the previous configuration.
Action Command
View usage information of the user
interface
display users [ all ]
View physical attributes and
configurations of the user interface
display user-interface console 0 [ summary ]
To Next Page
Loading...
