12 Patch Management
Quidway NetEngine80
Configuration Guide - Basic Configurations
12-6 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 04 (2009-12-20)
The three methods to upload a patch are FTP, TFTP and XModem.
Pre-configuration Tasks
Before loading a patch, complete the following tasks:
z
Ensuring that the router is started normally after power-on
z
Ensuring that the router can be logged in to
Data Preparation
Before running a patch, you need to obtain a patch that is consistent with the board.
Configuration Procedures
No. Procedure
1 Uploading a Patch to the Root Directory of the Master
2 Copying a Patch to the Root Directory of the Slave
12.3.2 Uploading a Patch to the Root Directory of the Master MPU
Upload a patch to the root directory of the Flash Memory of the master MPU.
The NE80 supports the uploading of files through FTP, TFTP and Xmodem. Choose an
uploading method based on the requirements.
12.3.3 Copying a Patch to the Root Directory of the Slave MPU
Do as follows on the router to be upgraded.
Step 1 Run:
copy source-filename slave#flash:/destination-filename
The patch is copied to the root directory of the Flash Memory of the slave MPU.
----End
If you need to copy multiple files to the Flash Memory of the slave MPU, repeat the preceding step.
To Next Page
Loading...
