Quidway NetEngine80
Configuration Guide - Basic Configurations 5 User Management
Issue 04 (2009-12-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5-13
The size of the history command buffer is configured.
By default, the size of history command buffer on user interface is 10 history commands.
----End
5.3.4 Configuring User Priority
Do as follows on the router:
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
user-interface aux 0
The AUX user interface view is displayed.
Step 3 Run:
user privilege level level
The user priority is set.
----End
5.3.5 Configuring Modem Attributes
Do as follows on the router that the user logs in to:
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
user-interface aux 0
The AUX user interface view is displayed.
Step 3 Run:
modem timer answer seconds
Set the period since the system receives the ring signal until waits for CD_UP, that is, the time
since the establishment of calling, from picking up to detecting carrier.
Step 4 Run:
modem auto-answer
Enable auto answer.
Step 5 Run:
modem [ both | call-in ]
To Next Page
Loading...
