2 Establishment of the Configuration Environment
Quidway NetEngine80
Configuration Guide - Basic Configurations
2-12 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 04 (2009-12-20)
Data Preparation
To complete the configuration, you need the following data:
z
Type of terminals
z
Terminal communication parameters
z
Modem communication parameters
Configuration Procedure
Step 1 Establish the physical connection as shown in Figure 2-7.
Step 2 Configure the AUX port to support the Modem dialup.
<Quidway> system-view
[Quidway] aaa
[Quidway-local-aaa-server] local-user huawei password cipher test1
[Quidway-local-aaa-server] local-user huawei service-type terminal
[Quidway-local-aaa-server] local-user huawei level 3
[Quidway-local-aaa-server] quit
[Quidway] user-interface aux 0
[Quidway-ui-aux0] authentication-mode aaa
[Quidway-ui-aux0] modem both
Step 3 Configure Modem parameters.
# Run the PC emulation terminal, see 2.4.4 Configuring the Connection Between the Remote
Terminal and the Router.
Press Enter on the PC emulation terminal or terminal until a command line prompt of the
Modem such as ">" appears.
Configure the Modem to meet the requirements of AUX communication.
For details, see Modem descriptions.
Step 4 Log in to the router.
Enter the user name and password in the remote terminal emulation program.
After authentication, a command line prompt such as <Quidway> appears.
Enter the command to check the running status of the router or configure the router.
Enter "?" for help.
For detailed operations, refer to the following chapters.
----End
To Next Page
Loading...
