Appendix A • Typical Operating System Settings
92
1037073-0001 Revision E
4. Select the Configure drop-down list. See Figure 76.
5. Select
Manually.
6. Type the appropriate IP address from the range of available IP
addresses in the
IP Address field. Do not use the numbers in
the examples, which are for illustrative purposes only.
7. Select the Apply Now button. The Mac is now configured.
Configuring a
Macintosh to support a
DHCP-enabled terminal
Follow the steps below to configure a terminal with DHCP
enabled on a Macintosh system.
1. Select
System Preferences from the Mac interface. The
Systems Preference menu appears.
Figure 76: Select Manually from the Configure drop-down list
To Next Page
Loading...
Need help?
General