Appendix A • Typical Operating System Settings
1037073-0001 Revision E
67
Control Center. You would have also written this on the
Quick Start Guide at the end of registration.
Windows Vista
1. Open the Control Panel by selecting Start → Control Panel →
Network Connections and double-click the
Network and
Dial-up Connections
icon. See Figure 46.
2. A list of Network adapters appears. A Local Area Connection
icon must be listed under LAN or High-Speed Internet. If not,
the network is not installed correctly.
Note: If your terminal will be connected to a router, you must
configure the router with the static IP address. Refer to the
instructions included with your router to configure it. You must
then enable the Dynamic Host Control Protocol (DHCP) on all
PCs connected to the router.
Note: If the Control Panel is in category view, select
Network and Internet Connections then select Network
Connections.
Figure 46: Network and Dialup Connections
To Next Page
Loading...
Need help?
General