Chapter 5 • Troubleshooting
1037073-0001 Revision E
47
Confirming transmit signal
The terminal will not function if satellite signals are not
transmitted properly.
1. At the System Control Center, click the Transmission Info
link. The Transmission Information page appears. See
Figure 40.
2. In the Transmit Status field, check the transmit (Tx) code.
If
Transmitter ready (TxCode 8) appears in the
Transmit Status field, the terminal is transmitting signals
properly. Proceed to the Confirming that TCP acceleration is
operational on page 48.
If any other code appears, the terminal is not transmitting
signals properly. Click the code, which is a link, and follow
the troubleshooting procedure that appears.
Figure 40: Confirming transmit signal
To Next Page
Loading...
Need help?
General