Appendix C • Conformance with standards and directives
102
1037073-0001 Revision E
Canada Class B warning
This Class B digital apparatus complies with Canadian
ICES-003.
Cet appareil numérique de la classe B est conforme á la norme
NMB-003 du Canada.
R&TTE (EU)
This product falls within the scope of the EU Radio Equipment
and Telecommunications Terminal Equipment (R&TTE)
Directive.
Telecommunications
standards
This section explains compliance with the IP over Satellite
standard (IPoS) and FCC Part 68.
IPoS
The Hughes HN System is compliant with the IP over Satellite
standard (IPoS) ratified by the Telecommunications Industry
Association (TIA-1008), first published in October 2003 and
issued as Revision A in May 2006.
FCC Part 68
This section applies to the HN7700S remote terminal only.
Standards to which Conformity is declared: FCC Part 68
Part 68 Compliance -- This equipment (Two-Way Hughes
System: Model Number: HN7700S) complies with Part 68 of the
FCC rules and requirements adopted by the ACTA. On the rear
panel of this equipment is a label that contains, among other
information, the product Part Number (P/N) in the format
XXXXXXX-XXXX and an eight digit Electronic Serial Number
(ESN). If requested, this information must be provided to the
Telephone Company.
The Two-Way Hughes system needs to be installed according to
the instructions. Coaxial cables (Rx and Tx) need to be grounded
at the point of entry. A plug and jack used to connect this
equipment to the premises wiring and telephone network must
comply with the applicable FCC Part 68 rules and requirements
Figure 82: IPoS symbol
To Next Page
Loading...
Need help?
General