Chapter 1 • Introduction
12
1037073-0001 Revision E
Power cycling the terminal
Some troubleshooting steps require you to restart the remote
terminal using the Restart
function in the System Control Center
(SCC) or to power cycle the remote terminal. Follow the
instructions precisely. Power cycling instead of using the Restart
function will destroy valuable troubleshooting data.
Preventive maintenance
To maintain your terminal:
• Keep the convection cooling vents free from blockage.
• Dust the terminal as often as needed with a soft cloth.
• Do not use solvent or abrasive powder when cleaning.
No internal cleaning or service is required. The terminal does not
contain user serviceable parts. Opening or tampering with the
remote terminal voids its warranty.
CAUTION
This User Guide contains some procedures that instruct
you to restart the remote terminal using the Restart
function
in the System Control Center. When so instructed, do not
power cycle the remote terminal. Doing so will destroy
valuable data used for troubleshooting.
CAUTION
When this User Guide instructs you to power cycle the
remote terminal, you should remove and then re-apply
power. If the terminal uses an AC/DC power supply,
disconnect the AC power cord from the power source
(power strip, wall outlet, or surge protector). If the terminal
uses a DC/DC power supply, disconnect the DC input cable
connector from the terminal’s power supply. In both cases
(AC/DC or DC/DC), do not unplug the power cord from the
back of the terminal. This could shock you and/or damage
the terminal.
To Next Page
Loading...
Need help?
General