IAI MCON-C - Teaching Tool; Instruction Manuals Related to this Product, Which Are Contained in the Instruction Manual (DVD)

21
1.1.2 Teaching Tool
A teaching tool such as PC software is necessary when performing the setup for position
setting, parameter setting, etc. that can only be done on the teaching tool.
Please prepare either of the following teaching tools.
No. Part Name Model
1
PC Software (Includes RS232C Exchange Adapter + Peripheral
Communication Cable)
RCM-101-MW
2
PC Software (Includes USB Exchange Adapter + USB Cable +
Peripheral Communication Cable)
RCM-101-USB
3
Touch Panel Teaching
(Standard Type / Deadman Switch Attached on the Left side Type /
Deadman Switch Attached on the Right side Type)
TB-01/TB-01D
/TB-01DR
4
Touch Panel Teaching
(Standard Type / Deadman Switch Type)
TB-02/TB-02D
5 Data Setter TB-03 Wired Link TB-03
1.1.3 Instruction manuals related to this product, which are contained in the
instruction manual (DVD).
No. Name Manual No.
1 MCON Controller Instruction Manual ME0341
2 PC Software RCM-101-MW/RCM-101-USB Instruction Manual ME0155
3
Touch Panel Teaching to Apply for TB-01/TB-01D/TB-01DR
Position Controllers Instruction Manual
ME0324
4
Touch Panel Teaching TB-02/TB-02D
Applicable for Position Controller, ELECYLINDER Instruction Manual
ME0355
5
Data Setter TB-03 Position Controller, ELECYLINDER Wired Link
Instruction Manual
ME0376
6
SSCNETⅢ/H Applicable Controller Instruction Manual
ME0352
7
MECHATROLINK-Ⅲ Applicable Controller Instruction Manual
ME0317
8 EtherCAT Motion Applicable Controller Instruction Manual ME0367
Chapter 1 Specications Check