84
3.4 Fieldbus Type Address Map
3.4.1 PLC Address Construction by each Operation Mode
The address domain to be occupied differs depending on the operation mode.
Refer to the example in Section 3.4.2 for the assignment.
y PLC Output → MCON Input (n is PLC output top word address to MCON)
(Note 1)
PLC output
Area
Simple
Direct
Mode
Positioner 1
Mode
Direct
Indication
Mode
Positioner 2
Mode
Positioner 3
Mode
ositioner 5
Mode
Remote I/O
Mode Details
n Gateway Control 0
n+1 Gateway Control 1
3.4.3
n+2 Demand Command
n+3 Data 0
n+4 Data 1
n+5 Data 2
n+6 Data 3
MCON Gateway
Control Area
n+7 Occupied Area
(Note 2)
3.4.11
n+8
Specified
Position No.
(Axis No.0)
Control
Signal/
Position No.
(Axis No.0)
Specified
Position No.
(Axis No.0)
Assignment
Area for
Axis No.0
n+9
Target
Position
(Axis No.0)
Occupied
Area
(Note 2)
Target
Position
(Axis No.0)
Control Signal
(Axis No.0)
Assignment
Area for
Axis No.1
Control
Signal
(Axis No.0)
Assignment
Area for
Axis No.1
n+10
Specified
Position No.
(Axis No.0)
Specified
Position No.
(Axis No.0)
Assignment
Area for
Axis No.2
Assignment
Area for
Axis No.2
n+11
Control
Signal
(Axis No.0)
Control
Signal
(Axis No.0)
Positioning
Width
(Axis No.0)
Assignment
Area for
Axis No.1
Assignment
Area for
Axis No.3
Assignment
Area for
Axis No.1
Assignment
Area for
Axis No.3
n+12
Velocity
(Axis No.0)
Assignment
Area for
Axis No.4
Assignment
Area for
Axis No.4
n+13
Occupied
Area
(Note 2)
Acceleration/
Deceleration
(Axis No.0)
Assignment
Area for
Axis No.5
Assignment
Area for
Axis No.5
n+14
Current
Limitation
Value
(Axis No.0)
Assignment
Area for
Axis No.6
Assignment
Area for
Axis No.6
n+15
Assignment
Area for
Axis No.1
Assignment
Area for
Axis No.1
Control
Signal
(Axis No.0)
Assignment
Area for
Axis No.7
Assignment
Area for
Axis No.7
n+16
to
n+23
Assignment
Area for
Axis No.1
Connected Axes Control Area
n+24
to
n+71
Assignment
Area for
Axis No.2
and later
Assignment
Area for
Axis No.2
and later
Assignment
Area for
Axis No.2
and later
Assignment
Area for
Axis No.2
and later
Assignment
Area for
Axis No.2
and later
3.4.4
to
3.4.10
Note 1 For CC-Link and CC-Link IE Field, from n to n+7 should be the bit address for
MCON input and n+8 should be the top address of the data register.
Note 2 This is the domain occupied unconditionally. Therefore, this domain cannot be used
for any other purpose.
3.4 Fieldbus Type Address Map
To Next Page
Loading...
