73
[Step 14] A confirmation window for Gateway Unit reboot opens. Click “Yes” button to accept
the reboot.
[Step 15] After rebooting, a confirmation window for parameter reading appears for
confirmation of the written contents. Click “Yes” button to accept the reading.
Once the reading process is complete, confirm that the written contents are
reflected.
If not written properly, do the process again from Step 1.
Reference: The settings are conducted in the special parameters for the process
of communication error, change in pressing method for Fieldbus Type
and speed unit change for Direct Indication Mode. Refer to 3.9 About
Gateway Parameter Setting Tool for the details.
3.2 Initial Setting
To Next Page
Loading...
