IBM Aptiva Series - Updating the CMOS Settings in Setup

Updating the CMOS settings in Setup 8-7
If you replace the system battery, you need to reset the
system date and time in Setup.
Follow these steps:
1.
Enter Setup.
2.
From the Setup main menu, select
Date and Time
.
3.
Set the date and the time.
4.
Press
Esc
to exit Setup.
5.
Use the left arrow key to select
Yes
, the press
Enter
to
save the settings in CMOS.
You may also change the time and date from the
Windows 95 desktop.
1.
Double-click on the
My Computer
icon.
2.
Double-click on the
Control Panel
icon.
3.
From the Control Panel, double-click on the
Date/
TIme
icon to display the items for changing the date
and time.
4.
Make the necessary changes then click on the
OK
button.
Updating the CMOS settings in Setup
When you add system board components, such as system
memory modules, your system’s Basic Input/Output System
(BIOS) detects the hardware changes and updates the
CMOS settings automatically. However, if you replace or
remove components, you might receive a message that asks
you to verify if the automatic detection changed the
configuration correctly.
To verify or correct the system configuration settings, enter
Setup. See the section “Entering Setup” on page 5-3.
v65xahb.book : chap-8.fm Page 7 Friday, January 16, 1998 4:27 PM