IBM Aptiva Series - V.42 Bis Commands

B-10 Appendix B: Modem information
V.42bis commands
Table 12: V.42bis commands
Command Function
>.0 Disable flow control
>.6 Enable RTS/CTS hardware flow control (data mode default)
>.< Enable XON/OFF software flow control
>80 Normal mode data link only (same as \N3)
>81 V.42 data link with fallback options
>82 Normal mode (speed buffering) data link only (same as \N0)
@0 Data compression disable
@ V.42bis/MNP5 data compression enabled
A$0 Normal mode (speed buffering) only
A$ Direct mode only
A$! MNP mode only
A$6 V.42/MNP/Normal auto-mode
A$< V.42 mode only
A80 Disable flow control (same as &K0)
A8 Enable XON/XOFF flow control (same as &K4)
A86 Enable CTS/RTS flow control (same as &K3)
A:0 Disable protocol result code appended to DCE speed
A: Enable protocol result code appended to DCE speed
v65xahb.book : app-b.fm Page 10 Friday, January 16, 1998 4:27 PM