Error codes and messages 9-21
186 Onboard ECP Parallel Port DMA
Conflict(s)
1.Remove all the add-on cards in the system.
2.Power on the system to see if it works without the cards.
3.Re-install the cards one by one to determine which of the cards
caused the error.
4.After determining the defective card or cards, replace the cards.
187 Onboard Floppy Drive DMA Conflict(s) 1.Remove all the add-on cards in the system.
2.Power on the system to see if it works without the cards.
3.Re-install the cards one by one to determine which of the cards
caused the error.
4.After determining the defective card or cards, replace the cards.
188 Onboard Floppy Drive I/O Address
Conflict(s)
1.Remove all the add-on cards in the system.
2.Power on the system to see if it works without the cards.
3.Re-install the cards one by one to determine which of the cards
caused the error.
4.After determining the defective card or cards, replace the cards.
189 Onboard IDE Secondary Channel I/O
Address Conflict(s)
1.Remove all the add-on cards in the system.
2.Power on the system to see if it works without the cards.
3.Re-install the cards one by one to determine which of the cards
caused the error.
4.After determining the defective card or cards, enter Setup and
set the Reset Resource Assignments parameter to Yes, then
reboot the system.
5.If the problem persists, set the Onboard IDE Secondary
Channel parameter to Disabled, then reboot the system.
190 Onboard Serial Port I/O Address
Conflict(s)
1.Enter Setup and change the onboard serial port I/O address or
disable it.
2.Reboot the system.
192 Onboard Parallel Port I/O Address
Conflict(s)
1.Enter Setup and change the onboard serial port I/O address or
disable it.
2.Reboot the system.
Table 4: Error codes and messages (Continued)
Error codes Error messages Corrective actions
Note:
If any of the errors persist after performing the listed corrective actions, see “Chapter 2: HelpWare support and services” on
page 2-1 for information on obtaining service.
v65xahb.book : chap-9.fm Page 21 Friday, January 16, 1998 4:27 PM
To Next Page
Loading...
