ICE Vulcan Service Manual
IntegraAuthentication-
Failure
‘Incompatible
Print-
head’- An
incompatible
printhead has been
detected.
•
Power off the machine and replace with
a
compatible printhead. Power on to
resume
operation.
•
If the problem persists, or if you wish to
pur-
chase spare parts, please call your
local ser-
vice representative for further
support. The
machine will not run until this
fault is resolved.
RewindCalibration
‘Label Waste Mandrel
Not Locked’
•
If there is a restriction stopping you from
fully closing the waste mandrel and this
fault
persists, please call your local service
repre-
sentative for further support and
refer to the
Service Manual.
Table 6-5: CLARiTY Error Messages (Continued)
To Next Page
Loading...