To Next Page

To Previous Page

4-20 Installing the Label Applicator

ICE Vulcan Service Manual

Secure the waste label backing to the waste mandrel by slotting

the

backing into the slot as indicated by the arrows on the waste

mandrel.

Mandrel Lock

Note: Right Hand unit shown

Figure 4-21: Mandrel Slot

Secure with the mandrel lock (a click sound is audible when

secured)

and wind the label web around the mandrel two or three

times until

the label web is secure.

Note: If the mandrel lock is not secured, the label speed will not be

accurate.

Place the supply disc on the supply mandrel and lock it if not

already

completed.

For information on removing the ribbon and labels from the LPA,

refer to

“How to Replace Label and Ribbon Web” on page 6-30.

Loading a Ribbon Roll on to the Ribbon Supply Mandrel

Remove the new ribbon from its packaging.

Unwind approximately 300 mm of ribbon from the reel (an

initial

length of the ribbon is ink free and is termed 'leader').

Fit the new ribbon to the supply mandrel, and ensure that the

reel is

pushed fully onto the mandrel.

Ice vulcan User Manual

Questions and Answers: