Icom IC-R30 - Page 160

7
OTHER FUNCTIONS
7-49
• DCR RX ID
Command: 20 0C01, 20 0C02
q, w
u ~ !0
0 X 0 X 0 XX XX X 0 X
0 X 0 X X X0 X0 X 0 X
0 (Fixed)
0 (Fixed)
!1, !2
e ~ y
q
Header flag data (First byte)
Data Description
bit7 0 (Fixed) —
bit6 0 (Reserved)
bit5 0 (Reserved)
bit4 0 (Reserved)
bit3
See the table below Type of call
bit2
bit1 0/1 0=Encryption OFF, 1=Encryption ON
bit0 0 (Reserved)
Data
Description
bit3 bit2
1 1 All call
1 0 Group call
0 1 Individual call
0 0 Not identified
w
Header flag data (Second byte)
Data Description
bit7 0 (Fixed) —
bit6 0 (Reserved)
bit5 0 (Reserved)
bit4 0 (Reserved)
bit3
0
(Reserved)
bit2
0
(Reserved)
bit1 0 (Reserved)
bit0 0 (Reserved)
e
~
y
: ID of the CALLER station (4 digits in Hexer decimal)
u
~
!0
: ID of the CALLED station (4 digits in Hexer decimal)
!1
,
!2
: UC (3 digits in decimal)
L If the UC, CALLER or CALLED station is not identied, “FF” is returned.
L FF: No signal has been received since the power was turned ON.
■ CI-V information
D Commands (Continued)