Icom ID-4100A

9
MENU SCREEN
9-8
TX Bass Cut, Normal, or Boost Sets the DV mode transmit audio bass lter
level to Cut, Normal or Boost.
TX Treble Cut, Normal, or Boost Sets the DV mode transmit audio treble lter
level to Cut, Normal or Boost.
Auto Reply OFF, ON, Voice, or Position Selects the Automatic Reply function.
DV Data TX PTT or Auto Selects to manually or automatically transmit
low speed data.
DV Fast Data
The DV Fast data mode sends data through
both the audio and data frames in the DV
mode. The data speed of the DV Fast data
mode (approximately 3480 bps) is 3.5 times
faster than the lowspeed data communication
mode (approximately 950 bps). In the DV Fast
data mode, no audio can be sent.
Fast Data OFF or ON Selects whether or not to use DV Fast data
mode for data communication in the DV
mode.
GPS Data Speed Slow or Fast
Set the GPS data transmission speed in the
DV Fast data mode.
TX Delay (PTT) 1sec~2sec~10sec, or OFF Set the TX delay time after releasing [PTT]
when the “DV Data TX” item is set to “PTT”
and data is sent using the DV Fast data
function.
Digital Monitor Auto, Digital, or Analog Selects the DV mode RX monitoring when
[SQL] is held down.
Digital Repeater Set OFF or ON Turns the digital repeater setting function ON
or OFF. This function is usable in any DV
mode except when using the DR function.
DV Auto Detect OFF or ON Turns the DV mode automatic detect function
ON or OFF.
RX Record (RPT) ALL or Latest Only The transceiver can record the data of up to
50 individual calls.
BK OFF or ON Turns the Break-in (BK) function ON or OFF.
The BK function enables you to break into a
conversation between two stations with call
sign squelch enabled.
EMR OFF or ON Turns the Enhanced Monitor Request (EMR)
communication mode ON or OFF.
After turning OFF the transceiver, the EMR
mode will be canceled.
EMR AF Level 0~19~32 Sets the audio output level when an EMR
mode signal is received.
Menu items and Default settings (Continued)
NOTE: The default settings shown in bold letters below are for the USA version.
The default settings may differ, depending on your transceiver version.
Previous view