Icom ID-4100A

9
MENU SCREEN
9-10
Remote MIC Key Selects the key function for [F-1] or [F-2] on
the supplied remote-control microphone.
During RX/Standby [F-1]:MODE [F-2]:Monitor Selects the key function to be used while
receiving or in the standby mode.
During TX [F-1]:T-CALL [F-2]:--- Selects the key function to be used while
transmitting.
Up/Down MIC Key Selects the key function for [UP] or [DN] on
the optional hand microphone.
During RX/Standby [UP]:UP [DN]:DOWN Selects the key function to be used while
receiving or in the standby mode.
During TX [UP]:--- [DN]:--- Selects the key function to be used while
transmitting.
One-Touch PTT(Remote MIC) OFF or ON Turns the One-Touch PTT function ON or
OFF.
PTT Lock OFF or ON Turns the PTT Lock function ON or OFF.
Busy Lockout OFF or ON Turns the Busy Lockout function ON or OFF.
Time-Out Timer OFF, 1min, 3min, 5min, 10min,
15min, or 30min
Selects the Time-Out Timer time options.
Active Band Single or All Enables
continuous frequency selection
across all bands by rotating [DIAL].
MIC Gain 1~2*~4 Sets the microphone sensitivity to suit your
preference.
Data Speed 4800bps or 9600bps Selects the data transmission speed for
low-speed communication, or between the
[DATA] jack and external modules like a GPS
receiver, and so on.
CI-V
CI-V Address 02h~9Ah~DFh Sets the transceiver's unique CI-V
hexadecimal address code.
CI-V Baud Rate 4800, 9600, 19200, or Auto Sets the CI-V code transfer speed.
CI-V Transceive OFF or ON Turns the CI-V Transceive function ON or
OFF.
CI-V Bluetooth➝REMOTE
transceive Address
00~DFh Sets the address to inhibit the external control
with CI-V for the transceiver through the [SP]
(REMOTE) jack.
Power OFF (With No
Controller)
OFF or ON Selects whether or not to automatically turn
OFF the transceiver when the controller is
disconnected from the transceiver.
Display Sets the Display options.
LCD Backlight Brightness 1~4 Selects the LCD backlight brightness level.
LCD Backlight Color White, Amber, Green, or Blue Selects the LCD backlight color.
Key Backlight Brightness 1~4 Selects the key backlight brightness level.
Key Backlight Color White, Amber, Green, or Blue Selects the key backlight color.
*
The default value may differ, depending on the transceiver version.
Menu items and Default settings (Continued)
NOTE: The default settings shown in bold letters below are for the USA version.
The default settings may differ, depending on your transceiver version.
Previous view