Icom ID-51A Advanced Instructions

9
D-STAR OPERATION <ADVANCED>
9-36
You can set unnecessary repeaters as scan skip tar-
gets. The selected repeaters are skipped during scan-
ning for faster selection and scanning.
You can set the skip setting to all repeaters in the se-
lected repeater group, or the individual repeater.
When a repeater is specified as a skip target, its
“USE (FROM)” setting is automatically set to “NO.” In
this case, the repeater cannot be selected in “FROM”
(Access repeater).
D Individual skip setting
Push [MENU] q .
Push D-pad( w ) to select the root item (“DV Memo-
ry”), and then push D-pad(Ent).
D-pad
(�)
(Ent)
Push D-pad( e ) to select “Repeater List,” and then
push D-pad(Ent).
Push D-pad( r ) to select the repeater group that in-
cludes the repeater you want to set the skip setting
on, and then push D-pad(Ent).
Push D-pad( t ) to select the repeater to be skipped
during the DR mode scan.
Push [QUICK] y .
Push D-pad( u ) to select “SKIP,” and then push D-
pad(Ent).
• “SKIP” appears on the selected repeater.
• Push [QUICK]
and select “SKIP” again, then push
D-pad(Ent) to cancel the skip setting.
• When “SKIP All ON” is selected, push D-pad(Ent) to set
all repeaters in the group as skip targets.
■ Skip setting for the DR mode scan
While in the DR mode, and
if you select “Repeater List”
on the FROM SELECT
screen, you can set the skip
settings in the same way as
described above.
Select the repeat-
er to set the skip
setting
Appears
Select the repeat-
er group.
Previous view

Icom ID-51A Specifications

General

Frequency Range	144-148 MHz, 430-450 MHz
Antenna Connector	SMA
GPS Receiver	Yes
Waterproof	IPX7
Modes	FM, DV
Weight	255 g
Memory Channels	1304 channels
Output Power	5W (High), 2.5W (Middle), 0.5W (Low)