5
BASIC OPERATION
5-8
D VFO mode
The VFO mode is used to set the desired frequency.
Push [V/MHz] q to select the VFO mode.
• When VFO mode is selected, push [V/MHz] then ro-
tate [DIAL] to change the frequency in 1 MHz steps. Or
push [V/MHz]
again for 10 MHz steps.
Rotate [DIAL] to set the operating frequency. w
• VFO mode
D Memory/Call channel/
Weather channel* mode
• Memory mode
Memory mode is used for operation on Memory chan-
nels, which store programmed frequencies.
• Call channel mode
Call channels are used for quick recall of most-often
used frequencies.
• Weather channel mode*
Weather channels are used for monitoring weather
channels from the NOAA (National Oceanographic and
Atmospheric Administration) broadcasts.
When the VFO mode is selected, push [M/CALL] q
to select the memory mode.
• “
” and the selected Memory channel number appear.
Push [M/CALL] w again to select the Call channel
mode, and then push again to select the Weather
channel mode.
• The Memory mode, Call channel mode or Weather chan-
nel mode* are alternately selected.
• While in the Call channel mode, the selected Call chan-
nel number (“C0” to “C3”) appears.
• While in the Weather channel mode*, the selected weath-
er channel number (“WX-01” to “WX-10”) appears.
Rotate [DIAL] to select a desired channel. e
• Only programmed Memory channels can be selected.
• See p. 12-4 for memory programming details.
*Appears in only the U.S.A. version transceivers.
• Memory mode
Appears
• Call channel mode
D DR (D-STAR Repeater) mode
The DR (D-STAR Repeater) mode is used for D-STAR
repeater operation. In this mode, you can easily select
the preprogrammed repeaters and UR call signs by ro-
tating [DIAL].
Hold down q for 1 second to select the DR
mode.
Rotate [DIAL] to select a desired access repeater. w
• DR mode
■ Selecting the Mode
• Weather channel mode*
Appears
Hold down
Memory mode
Call channel mode
WX channel* mode
DR mode
Push
VFO mode
to select
to select
Push
to alternately select
To Next Page
Loading...
Need help?
General
