8
D-STAR OPERATION <BASIC>
8-14
The destination station call sign can be directly input.
Hold down q for 1 second.
• The DR mode is selected.
Push D-pad( w ) to select “TO,” and then push D-
pad(Ent).
Push D-pad( e ) to select “Direct Input (UR).”
Push D-pad(Ent) to enter the edit mode. r
Rotate [DIAL] to select a desired character. t
(Example: J)
• A to Z, 0 to 9, / and a space can be selected.
• Rotate [DIAL] counter clockwise to enter a space.
• Push [CLR]
to delete the selected character, or hold
down [CLR]
to continuously erase the characters,
first to the right, and then to the left of the cursor.
Push D-pad( y ) to move the cursor to the second
digit.
Repeat steps u t and y to enter a call sign of up to 8
characters, including spaces.
(Example: First, J, then M, then 1, then Z, then L,
then K.)
After entering, push D-pad(Ent) twice to program. i
• “JM1ZLK” is displayed on “TO.”
• After programming, you can correct the call sign in the
DIRECT INPUT (UR) screen.
• The programmed call sign remains on the DIRECT IN-
PUT (UR) screen, until inputting a new call sign.
“TO” (Destination) setting (Continued) ■
D Directly inputting (UR)
Example: Directly input the call sign “JM1ZLK.”
If the programmed call sign is duplicated in “Your
Call Sign” memory, the name is displayed. (Only
when the name has been programmed.)
Completed
[DIAL]
To Next Page
Loading...
Need help?
General
