9
D-ST
AR OPERA
TION <AD
V
ANCED>
9-23
D New repeater programming
Repeater group selection1.
q Push [MENU]
.
w Push D-pad() to select the root item (“DV Memo-
ry”), and then push D-pad(Ent).
e Push D-pad() to select “Repeater List,” and then
push D-pad(Ent).
• The repeater groups are displayed.
r Push D-pad() to select the desired repeater group
to be programmed, and then push D-pad(Ent).
• The repeater list of the selected repeater group is dis-
played.
t Push [QUICK] .
y Push D-pad() to select “Add,” and then push D-
pad(Ent).
• The REPEATER LIST EDIT screen is displayed.
Required items for the communication cases D
Repeater list
contents
Used as
an access
repeater
Used as a
destination
repeater
Used for a
simplex com-
munication
NAME – – –
SUB NAME – – –
CALL SIGN
✔ ✔
This item MUST
be blank.
GW CALL
SIGN
✔
(For Gateway call)
✔
–
GROUP – – –
USE(FROM)
✔
–
✔
FREQUENCY
✔
–
✔
DUP
✔
–
This item MUST
be set to “OFF.”
OFFSET FREQ
✔
– –
POSITION – – –
LATITUDE – – –
LONGITUDE – – –
UTC OFFSET
– – –
☞ Continued on the next page.
* When you want to add a new repeater by editing a pro-
grammed repeater memory contents, select “Edit.” In this
case, after
programming, be sure to
select “<<Add
Write>>.
”
If you select “<<Overwrite>>,” the original repeater pro-
grammed contents are overwritten.
■ Repeater list programming
This section describes how to manually program new
repeater into the repeater list.
The required setting items differ, depending on the re-
peater use. Be sure to confirm the required items, as
shown to the right.
NOTE: To program a repeater into the repeater list,
the repeater’s call sign MUST be entered.
Select
*
To Next Page
Loading...
Need help?
General
