Icom ID-51A

9
D-STAR OPERATION <ADVANCED>
9-24
Repeater list programming (Continued) ■
Repeater name programming2.
u Push D-pad(
) to select “NAME,” and then push D-
pad(Ent) to enter the repeater name edit mode.
D-pad
(�)
(Ent)
i Rotate [DIAL] to select a desired character.
• Selectable input characters are Upper case letters, Low-
er case letters, Numbers or Symbols.
• The selected character blinks.
• Push D-pad() to move the cursor backward or forward.
• While selecting a character, push [QUICK]
to change
the character to an upper case or lower case letter.
• While selecting a digit, push [QUICK]
to open the
input mode selection window.
• A space can be entered in any input mode selected.
• Rotate [DIAL] counter clockwise to enter a space.
• Push [CLR]
to delete the selected character, or hold
down [CLR]
to continuously delete the characters,
first to the right, and then to the left of the cursor.
• See page 2-7 for programming details.
o Push D-pad() to move the cursor to the second
digit.
!0 Repeat steps i and o to enter a name of up to 16
characters, including spaces.
!1 After entering the name, push D-pad(Ent).
Character type
selection screen
Example:
“East Tokyo” is
entered.
☞ Continued on the next page.
Shows the currently se-
lected character type
Previous view