8
D-STAR OPERATION <BASIC>
8-10
“TO” (Destination) setting (Continued) ■
D Using the “Gateway CQ” (Gateway call)
The destination repeater is set in “TO” to call a station
through your local area (access) repeater, gateway
repeater, the internet and then to your destination re-
peater.
q Hold down for 1 second.
• The DR mode is selected.
Push D-pad( w ) to select “TO” (Destination), and then
push D-pad(Ent).
Push D-pad( e ) to select “Gateway CQ,” and then
push D-pad(Ent).
• The REPEATER GROUP screen is displayed.
Push D-pad( r ) to select the repeater group where
your destination repeater is listed, and then push D-
pad(Ent).
• Example: “11: Japan”
Push D-pad( t ) to select the destination repeater,
and then push D-pad(Ent).
• Example: “Hamacho”
• “Hamacho” is displayed on “TO.”
Example: Making a gateway CQ call to (Japan; Hama-
cho) from the “Hirano” repeater.
Completed
After selecting a repeater, you can select other re-
peater preset in your transceiver by rotating [DIAL].
Means this repeat-
er is programmed
as the 282th of the
690 repeaters on
the repeater list.
To Next Page
Loading...
Need help?
General
