Icom ID-51A Advanced Instructions

16
MENU SCREEN
16-18
■ Scan items
Pause Timer (Default: 10sec)
Scan > Pause Timer (Pause Timer)
Select the scan Pause time. When receiving a signal, the scan pauses for the
scan Pause timer Time.
• 2 to 20sec : When a signal is received, the scan pauses for 2 to 20 seconds
(set in 2 seconds steps).
• HOLD : When receiving a signal, the scan pauses until it disappears.
Resume Timer (Default: 2sec)
Scan > Resume Timer (Resume Timer)
Select the scan Resume Timer time.
When a received signal disappears, the scan resumes according to the scan
Resume Timer setting.
• 0sec : The scan resumes immediately after the signal disappears.
• 1 to 5sec : The scan resumes 1 to 5 seconds after the signal disappears.
• HOLD : The scan remains paused for the Pause Timer setting, even if
the signal disappears.
NOTE: Rotate [DIAL] to resume the scan.
The Resume Timer must be set shorter than the Pause Timer, otherwise
this timer does not work properly.
Temporary Skip Timer (Default: 5min)
Scan > Temporary Skip Timer (Temporary Skip Timer)
Set the Temporary Skip Timer to 5, 10 or 15 minutes.
When the time is set, the specified frequencies are skipped for this set period
during a scan.
Previous view

Icom ID-51A Specifications

General

Frequency Range	144-148 MHz, 430-450 MHz
Antenna Connector	SMA
GPS Receiver	Yes
Waterproof	IPX7
Modes	FM, DV
Weight	255 g
Memory Channels	1304 channels
Output Power	5W (High), 2.5W (Middle), 0.5W (Low)