16
MENU SCREEN
16-70
Function items (Continued) ■
VOX Delay (Default: 0.5sec)
Function > VOX > VOX Delay (VOX Delay)
Set the VOX Delay to 0.5, 1.0, 1.5, 2.0, 2.5 or 3.0 seconds.
The VOX Delay is the amount of time the transmitter stays ON after you stop
speaking before the VOX switches to receive.
VOX Time-Out Timer (Default: 3min)
Function > VOX > VOX Time-Out Timer (VOX Time-Out Timer)
Set the VOX Time-Out Timer to 1, 2, 3, 4, 5, 10 or 15 minutes to prevent an
accidental prolonged transmission.
To disable the function, set it to “OFF.”
• OFF : Turns the function OFF.
• 1, 2, 3, 4, 5, 10 or 15 min : If a continuous transmission exceeds the set pe-
riod, the transmission will be cut off.
Headset Select (Default: Other)
Function > VOX > Headset Select (Headset Select)
Select the headset type to be connected.
• HS-95 : Select when the HS-95 is connected.
• Other : Select when the HS-94 or HS-97 is connected.
CI-V Address (Default: 86)
Function > CI-V > CI-V Address (CI-V Address)
To distinguish equipment, each CI-V transceiver has its own Icom standard
address in hexadecimal code.
The ID-51A/E’s default address is 86.
When 2 or more ID-51A/Es are controlled through a PC at the same time, set
a different address for each device between 01h and DFh (hexadecimal).
CI-V Baud Rate (Default: Auto)
Function > CI-V > CI-V Baud Rate (CI-V Baud Rate)
Set the CI-V data transfer speed to 300, 1200, 4800, 9600, 19200 bps or
Auto.
When “Auto” is selected, the baud rate is automatically set according to the
data rate of the controller.
To Next Page
Loading...
Need help?
General
