13
SCAN OPERATION
13-4
Scan (Continued) ■
D When a signal is received
When a signal is received, the scan pauses for approxi-
mately 10 seconds (default), then resumes.
The scan resumes approximately 2 seconds (default)
after the signal is disappears.
To manually resume the scan, rotate [DIAL].
• These settings can be changed in the MENU screen.
(p. 16-18)
(MENU > Scan > Pause Timer)
(MENU > Scan > Resume Timer)
D Scan name
A desired name can be assigned to each PROGRAM-
CH (**A/**B). (p. 12-10)
By selecting the scan name, the scanning frequency
range will be set.
D Scan Stop Beep function
The Scan Stop Beep function sounds a beep when a
signal is received.
The function can be turned ON in the MENU screen.
(p. 16-80)
(MENU > Sounds > Scan Stop Beep)
D Scan function during Dualwatch opera-
tion
When the scan function is used during the dualwatch
operation, the SUB band audio signal may be muted,
depending on the operating band or mode.
And, the audio output may be interrupted when the fre-
quency or operating mode is switched while scanning.
❍ SUB band mute status
MAIN band SUB band
DV mode
DV mode
FM-N mode
FM-N mode
DV mode
FM-N mode
AIR band AIR band
Scan name
“Scan 0”
The scan type selecting screen.
The S-meter shows the
received signal strength.
Blinks
Blinks
MAIN
band
SUB
band
Example: Full scan is running on the MAIN
band, and the AIR band is selected
on the SUB band.
When an AIR band frequency is
scanned on the MAIN band, the
SUB band audio signal is muted.
To Next Page
Loading...
Need help?
General
