Icom ID-51A Advanced Instructions

9
D-STAR OPERATION <ADVANCED>
9-44
You can check the repeater list default values using the
supplied CS-51 c l o n i n g s o f t w a r e .
The ICF (Icom Cloning Format) file, including the de-
fault repeater list, can also be downloaded from the
Icom website.
http://www.icom.co.jp/world/support/download/firm/
index.html
If you open the downloaded ICF file with the CS-51,
the repeater list default values are displayed on the
screen.
To reset the programmed repeater list to the default,
write the ICF file to the transceiver using the CS-51*
1
,
or copy the ICF file to the microSD card*
2
, and then
write to the transceiver.
*
1
See the CS-51 instruction manual when using the
CS-51.
*
2
See page 2-9 when using the microSD card.
D Opening the default repeater list
Start the CS-51. q
• See the CS-51 instruction manual for how to install the
software.
Click [Open] to open the ICF file. w
Click the [Repeater list] folder to show the default e
repeater list.
■ About the repeater list default values
Select
Double-
click
Click
You can see the
default values of
the repeater list
on the CS-51.
When the ICF file is opened on the CS-51.
Previous view

Icom ID-51A Specifications

General

Frequency Range	144-148 MHz, 430-450 MHz
Antenna Connector	SMA
GPS Receiver	Yes
Waterproof	IPX7
Modes	FM, DV
Weight	255 g
Memory Channels	1304 channels
Output Power	5W (High), 2.5W (Middle), 0.5W (Low)