11
VOICE MEMORY FUNCTION
11-13
The transceiver starts to record the transmitted audio
at the same time the [PTT] switch is pushed.
After transmitting, the transceiver receives signal in a
given amount of time, it also records the received au-
dio. Therefore, you can record all communication audio
to use this function.
Push [MENU] q to enter the Menu screen.
Push D-pad( w ) to select the root item (Voice Memo),
and then push D-pad(Ent) to go to the next level.
( MENU > Voice Memo > QSO Recorder > Recorder
Set > PTT Auto REC)
Refer to the menu sequence show directly above e
and push D-pad() to select, and then D-pad(Ent)
to enter, one or more times until the last screen is
displayed.
Push D-pad( r ) to select “ON,” then push D-pad(Ent)
to save.
• OFF : The transceiver does not start to record when the
[PTT] switch is pushed.
• ON : The transceiver starts to record when the [PTT]
switch is pushed.
Push [MENU] t to exit the Menu screen.
NOTE: When you set PTT AUTO REC to ON, see
the notes below.
• The transceiver also starts to record audio when
pushing the optional microphone’s [PTT] switch,
transmitting using with the VOX function or CI-V re-
mote controller.
• All transmit audio is recorded when “TX&RX” is set
in the “REC Mode” item on the Menu screen.
• When the transceiver receives a signal less than
10 seconds after transmitting, the transceiver also
records the receive audio.
• In addition, when the transceiver receives a signal
less than 10 seconds after the signal is received, it
also records the receive audio.
■ Start to record when the [PTT] switch is pushed
To Next Page
Loading...
