9
D-ST
AR OPERA
TION <AD
V
ANCED>
9-25
Repeater list programming (Continued) ■
Repeater sub name programming3.
!2 Push D-pad(
) to select “SUB NAME,” and then
push D-pad(Ent) to enter the repeater sub name edit
mode.
!3 Rotate [DIAL] to select a desired character.
• Selectable input characters are Upper case letters, Low-
er case letters, Numbers or Symbols.
• The selected character blinks.
• Push D-pad() to move the cursor backward or forward.
• While selecting a character, push [QUICK]
to change
the character to an upper case or lower case letter.
• While selecting a digit, push [QUICK]
to open the
input mode selection window.
• A space can be entered in any input mode selected.
• Rotate [DIAL] counter clockwise to enter a space.
• Push [CLR]
to delete the selected character, or hold
down [CLR]
to continuously delete the characters,
first to the right, and then to the left of the cursor.
• See page 2-7 for programming details.
!4 Push D-pad() to move the cursor to the second
digit.
!5 Repeat steps !3 and !4 to enter a sub name of up to
8 characters, including spaces.
!6 After entering the name, push D-pad(Ent).
Character type
selection screen
Example:
“Japan” is en-
tered.
☞ Continued on the next page.
Shows the currently se-
lected character type
To Next Page
Loading...
Need help?
General
