Icom ID-51A Advanced Instructions

9
D-STAR OPERATION <ADVANCED>
9-41
!1 Push D-pad() to select “CALL SIGN,” and then
push D-pad(Ent).
!2 Rotate [DIAL] to select the first character.
(For example: J)
• A to Z, 0 to 9, / and a space can be selected.
• A space can be entered in any input mode selected.
• Push [CLR]
to erase the selected character, or hold
down [CLR]
to continuously erase the characters af-
ter the cursor.
!3 Push D-pad() to move the cursor to the second
digit.
!4 Repeat steps !2 and !3 to enter a call sign of up to 8
characters, including spaces.
(For example: First, J, then M, then 1, then Z, then
L, then K.)
!5 After entering, push D-pad(Ent).
!6 Push D-pad() to select “<<Add Write>>,” and then
push D-pad(Ent).
!7 Push D-pad() to select “YES,” and then push D-
pad(Ent).
!8 Push [MENU] to exit the MENU screen.
[DIAL]
To cancel the programmed data:
To cancel the programmed
data, push [CLR] to
display “Cancel edit?.” Push
D-pad() to select “YES,”
and then push D-pad(Ent)
to cancel programming
and the display returns the
YOUR CALL SIGN screen.
“JM1ZLK” is entered.
Select
When you select
“Edit” in step t on
the previous page
“<<Overwrite>>”
appears here. If
you select “<<Over-
write>>,” the pro-
grammed call sign
overwrites the origi-
nal call sign.
“TOM/JM1ZLK”
is programmed
into the Your Call
Sign memory.
When “TOM” is selected,
“JM1ZLK” is displayed here.
Your (destination) call sign programming (Continued) ■
Previous view

Icom ID-51A Specifications

General

Frequency Range	144-148 MHz, 430-450 MHz
Antenna Connector	SMA
GPS Receiver	Yes
Waterproof	IPX7
Modes	FM, DV
Weight	255 g
Memory Channels	1304 channels
Output Power	5W (High), 2.5W (Middle), 0.5W (Low)